Guideline J-09
Example terms are defined in the following table: (*): For Category I equipment, that includes “Other parts” as defined in PED Guideline G-, which are elements attached to CCPR (including those attached to PP and MPBP). EXAMPLE: Essential Safety Requirements applying to CCPR, also apply to PP and MPBP. Note 1: Delivering an equipment may […]
Guideline I-19
There are no specific provisions in the directive on how the manufacturer must indicate that such equipment complies with the PED. Nevertheless, the manufacturer must supply adequate instructions for use, and provide markings to permit identification of the manufacturer or its authorized representative established within the Community. However, manufacturers should be aware that it is […]
Guideline G-05
Note:
Guideline G-06
The main pressure-bearing parts are the parts, which constitute the envelope under pressure, and the parts which are essential for the integrity of the equipment. Examples of main pressure-bearing parts are shells, ends, main body flanges, tube sheet of exchangers, tube bundles. The materials for these main pressure-bearing parts of equipment of categories II to […]
Guideline G-07
It is the quality (assurance) system of the material manufacturer which shall have undergone a specific assessment for materials (and not the competent body). Note:See also PED Guideline G-02.
Guideline G-16
In practice, this requirement is satisfied when the material manufacturer has a quality assurance system of at least EN ISO 9001 type, certified by a competent body (according to the definition given in PED Guideline G-02) established as a legal entity within the European Community, and when the field of validity of the certification specifies […]
Guideline G-24
Yes, the material properties used in design of the equipment, e.g. yield strength and impact properties, must be based on those of the specification which are affirmed by the material manufacturer. Note 1:This does not mean that the values of the specification need to be written on the certificate. It is sufficient for the material […]
Guideline G-25
Continuously machine-welded tubes, i.e. tubes made from coils as starting materials in an automatic process, which are usually heat treated after welding shall be in the terms of certification procedures considered as materials provided the essential safety requirements (ESRs) of Annex I section 4 “Materials” as well as applicable ESRs of Annex I section 3 […]
Guideline G-27
The equipment manufacturer shall be able to confirm that the material manufacturer’s quality system certificate meets the requirements of the third paragraph of section 4.3 of Annex I (field of validity of the certification, range of validity of certification, establishment of the competent body as a legal entity within the European Union, accreditation). The equipment […]