Guideline I-16
The manufacturer of CE-marked pressure equipment or assembly should be aware that the EU declaration of conformity must be made available for national authorities immediately upon request. Otherwise the presumption of conformity as provided for in Article 5, paragraph 1, is in doubt. For this purpose the manufacturer or his authorised representative established within the […]
Guideline I-23
Pressure equipment and assemblies bearing the CE marking and the EU declaration of conformity are presumed to conform with the requirements of the PED. Therefore, during inspections under national legislation of such products, performed before putting into service, it is not permissible that : Note 1:The said inspections may e.g. verify whether the pressure equipment […]
Guideline I-24
(1) All technical (design, manufacturing, conformity assessment) requirements addressing hazards related to pressure are covered by the PED. Any additional national requirements related to pressure would constitute an impediment of the free movement of products falling into the scope of the PED and are not permissible. The following are examples of non-permissible additional requirements: These […]