Guideline C-03
The assemblies set out in the 2nd subparagraph (the derogation) in Article 4 paragraph 2 must comply with the essential requirements referred to in 2.10, 2.11, 3.4, 5(a) and 5(d) of Annex I of the Directive, even if all the items of pressure equipment comprising the assembly fall under Article 4 paragraph 3 (SEP). Reason:This […]
Guideline C-05
Yes, in accordance with Article 19 paragraph 1, but the identification mark of the notified body is left out if the manufacturer has selected the use of module B EU-Type examination – design type. Reason:The applied conformity assessment procedure is defined in table 4 of the Annex II, where the modules B EU-type examination – […]
Guidelien C-11
Only if it is shown that such pre-PED item of pressure equipment also complies with the requirements of the directive. If an assembly, as referred to in Article 4 paragraph 2, is placed on the market after 29 May 2002 then it must comply with the Directive. This requirement can only be met if the […]
Guideline C-14
As stated in PED Guideline C-05, Article 4 paragraph 2 (last sentence) assemblies comprise, as a minimum, the boiler with its protective devices. However, it is sufficient that the manufacturer of the boiler obtains an EU- Type examination – design type certificate, provided that he clearly specifies in his installation instructions the suitable protective device […]